Owner`s manual

3.3 Wiring layout
+12V, GND, REM connection chart
We recommend using 12 AWG speaker cables to obtain intended performance.
Run 12 AWG speaker cables from your speakers to the amplifier’s mounting location.
Keep the speaker cables seperate from the power cables and and the amplifier’s input cables.
Use grommets where the cables have to penetrate the vehichle’s chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 1cm, 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause a short circuit.
Crimp spade plugs over the cable ends or tin the ends with solder to provide a solid terminal.
Connect the cable ends to the amplifer as shown in the speaker wiring diagram.
Head unit
7
Remote turn on
M1u
*
850A (External fuses)
*
Keep GROUND of equal length.
This drawing is for illustration
purposes only!