Owner`s manual

FEATURES
Circuit Configuration
Frequency Response
Signal to Noise Ratio
Input Sensitivity
Input Level Selector
Crossover
High Pass Filter
Low Pass Crossover Range
Subsonic Crossover Range
Bass Boost
Phase
Output Master / Input Slave
Remote Control
Damping Factor
Power Terminal gauge
B2 series output power
POWER @ 4OHM POWER @ 2 OHM POWER @ 1OHM
Mono 570W x 1 1000W x 1 1800W x 1
POWER @ 4OHM POWER @ 2 OHM POWER @ 4 OHM MONO
Quattro 100W x 4 160W x 4 320W x 2
Mono
Ultra Class D Mono
: 20Hz ~ 250Hz
: 100dB
: 6V ~ 0.2V
: No
: 24dB / Oct
: no
: 20Hz ~ 200Hz
: 10Hz ~ 50Hz
: 0 ~ 9dB
: 0 ~ 180 Degree
: YES
: YES
: 250<
: 0 ga x 1
( Linked : 360A )
All features are subject to change in the continuing effort to improve the products without notice
1. FEATURES
2. DESIGN FEATURES
1) Mono will allow stable operation as a single unit @ 4/2/1 ohms impedance.
Mono will allow daisy chain connections @ impedances down to 2 ohms.
2) Quattro 4 ch class AB amplifier will allow stable operation @ 4/2 ohms stereo and 4 ohms mono.
3) B2 amplifiers offer an advanced protection circuit for the benefit of the user.
Speaker short circuitry, DC offset, Voltage sensor & thermal protection.
4) The B2 pcb has been designed using a double sided board and features high current mosfet
switching devices.
Mono has a 24 dB slope/Oct low pass & subsonic filter.
Quattro has a 12 dB slope/Oct high pass and low pass filter
5) Mono & Quattro offer wired remote level control which allows easy gain adjustment from
the drivers seat.
6) Mono can be used in a daisy chain connection. This will allow bridging of 2 mono amplifiers
@ 2 ohms to produce twice the power of one unit @ 1 ohm
Quattro
4ch Class AB
: 20Hz ~ 30KHz
: 105dB
: 6V ~ 0.2V
: LOW/HIGH
: 12dB / Oct
: 50Hz ~ 1KHz
: 30Hz ~ 500Hz
: 10Hz ~ 100Hz
: 0 ~ 18dB
: No
: No
: YES
: 250<
: 0 ga x 1
B2 has through years of dedication introduced our line of Mono & Quattro amplifiers.
The B2 line up are made to fullfil our philosophy for amplifiers; A variety of applications, highest
possible efficiency and great appearance.
The B2 amplifiers are designed to produce high power levels even from stock electrical systems.
High efficiency is created from updating every stage through the amplifiers' circuit. High speed
controller chipsets, efficient power devices, precise thermal management and the best engineering
are the cornerstones of the B2 amplifier series.
1
Fuse Rating : 180A : 3 x 30A
(13,8V, 0,02% THD)