Owner`s manual

2. Panel layout
Mono
INPUT
Signal input from the head unit. A minimum level
input of 0.2V is essential for correct operation.
OUTPUT
Output RCA for signal routing to another amplifier.
POWER & PROTECTION INDICATOR
Power LED, Blue-lit shows correct operation.
Protect LED, Red-lit shows general malfunction,
faulty connection or thermal protection.
GAIN (6V ~ 0.2V)
Matching of the output voltage from the head unit’s
RCA line-outs to the input section.
SUBSONIC FILTER (10Hz ~ 50Hz @ 24dB/Oct)
Adjusts the subsonic cut off point to eliminate
frequencies within the filter’s range.
BASS BOOST
Variable bass boost with 0-9 dB @ 45 Hz.
REMOTE LEVEL CONTROL PORT
Connection of external level control.
(The Better Bass Remote can be connected for additional features).
LOW PASS FILTER (35Hz ~ 250Hz @ 24dB/Oct)
Adjusts the cut off point for the low pass filter
within the filter’s range.
PHASE CONTROL
Variable phase adjustment from 0-180 degrees.
OUTPUT MASTER / INPUT SLAVE
For daisy chain connection of 2
Mono amplifiers.
Minimum impedance is 2 .
INPUT
Signal input from the head unit. A minimum level
input of 0.2V is essential for correct operation.
GAIN (6V ~ 0.2V)
Matching of the output voltage from the head unit’s
RCA line-outs to the input section.
HIGH PASS FILTER (20Hz~500Hz @24dB/Oct)
Adjusts the cut off point for the high pass filter
within the filter’s range.
HIGH PASS MULTIPLIER (x1, x 10)
Multiplies the high pass frequency by x 1, x 10.
The range of the filter in x 10 mode is 200Hz ~ 5KHz .
HIGH PASS FILTER SWITCH
Makes the bandwith of the filter range operate
in high pass mode when it is in the on position.
In off position, the filter will not affect the frequency
range of the amplifier.
LOW PASS FILTER (50Hz~500Hz @24dB/Oct)
Adjusts the cut off point for the low pass filter
within the filter’s range.
LOW PASS MULTIPLIER (x1, x 10)
Multiplies the low pass frequency by x 1, x10.
The range of the filter in x 10 mode is 500Hz ~ 5KHz.
Quattro
4