Owner`s manual
10
Strapped Control panel setting Master / slave 1
slave 1
master
L
Head unit
To link the master and slave 1 amplier RCA connection follow the steps below.
Keep in mind ampliers needs to be switched o, linking the ampliers when switched on may cause harm and can void your warranty!
Step 1. Connect RCA from Head Unit / output source into master amplier RCA input.
If only one output is available, then use a Y-split to connect both L & R.
Step 2. Locate the Master / Slave 1 / Slave 2 switch on the right side of the control panel on the Master amplier.
Set the switch to Master position.
step 3. Connect a single RCA from the RCA OUT on the master amplier.
Step 4. Locate the Master / Slave 1 / Slave 2 switch on the right side of the control panel on the Slave 1 amplier.
Set the switch to Slave 1 position.
Step 5. Connect the single RCA cable from the Master amplier’s Rca out to the slave 1 amplier’s single RCA IN.