Owner`s manual
4
Panel layout
Mono
INPUT BASS BOOST
RCA signal input for Left & Right channel. Variable signal boost of the BASS FREQ chosen
A minimum of 0.2 v input signal is required for correct with 0 dB ~ 9 dB.
operation.
POWER & PROTECTION INDICATOR LPF (LOW PASS FILTER 35 Hz ~250 Hz, 24 dB/oct)
Power LED, blue light shows correct operation, Adjusts the cut o point for the low pass crossover
Protect LED, red light shows general malfunction, faulty at the frequency chosen.
connection or thermal protection.
REMOTE LEVEL CONTROL PORT
GAIN (6V~0.2v)
Connection of external signal level control.
Adjusts signal input voltage from the source CAUTION, the amplier needs to be gained in accordance
to match the ampliers input stage. with the remote to avoid excessive signal boost.
0.2 V ~ 6 V is the operational voltage.
Voltages beyond may cause damage.
MASTER / SLAVE 1
Enables daisy chain (strapped mode) of 2 ampliers.
SUBSONIC SWITCH (OFF / ON) Minimum warrantied impedance is 2 ohm.
ON setting will activate the subsonic crossover See page 8 for complete instructions on how to
at 35 Hz & 24 dB per octave. It is highly recommended run the ampliers in linked mode.
to use the ON setting to avoid unnecessary strain to
your sound system.
MASTER / SLAVE 2
For connection of multiple ampliers in a chain.
BASS FREQ (35 Hz ~100 Hz) The MASTER amplier’s settings (Gain, Bass Freq / Boost,
Adjustable bass boost frequency between 35 Hz ~ 100 Hz. crossover point will be routed to subsequent ampliers
Use with caution, boosting the wrong frequency may conict being set as SLAVE2. The MASTER amplier will control
with the performance of your enclosure design. all settings of the SLAVE2 ampliers.
(IT IS NOT A STRAP MODE)