Owner`s manual
9
Linking or strapping makes 2 ampliers work as a single amplier.
This conguration will near double the rated output power.
Follow the instructions carefully as it can cause harm to your system if done incorrect.
Speaker Impedance 2 ~ 16 ohm
Strapped speaker wiring - Master / slave 1
Speaker impedance 2 Ohm ~ 16 Ohm
Loads under what is specied will cause excessive heat & the amplier
will reach thermal at a faster rate & will eventually go into protect.
Strapped impedance load under 2 ohm is not warranted!
To link the master and slave 1 amplier speaker connection follow the steps below.
step 1.
Run the
positive (+) speaker cable from the master amplier’s speaker output to the
positive terminal (+) of the subwoofer.
step 2.
Run the positive (+) speaker cable from the slave 1 amplier’s speaker output to the
negative terminal (-) of the subwoofer.
Step 3.
Connect both ampliers together by running a cable from negative speaker output on master amplier
to negative speaker output on slave 1 amplier.
slave 1