User guide

3. The green led (6) indicator will flash as the baby breathes or moves.
4. Turn off the unit (press the red button (1) twice) before you take the baby out of the bed. (If
the alarm is on the unit can be switched off pressing the red button(1) once)
While everything goes well
After placing the baby and turning the unit on the digital display(2) shows the sensitivity level
every 2 seconds and the green light flashes.
(Sensitivity level 9: max, 1: min, 0: no movement (alert)).
Setting the sensitivity (threshold) level
1. Turn the control unit off and wait a few seconds.
2. Press the red button(1) and hold it for 20 seconds until you see the „L”-„E” letter on the
digital display(2) then release the button.
3. On the display the numbers are changing slowly from 1 to 9.
4. When the required sensitivity (threshold) level is displayed press the red button(1).
5. Now the new level setup is stored and the unit turns on automatically.
Important Information:
Decreasing the threshold level, the sensor pads will be more sensitive in terms of the
surronding intrusive vibrations e.g.: a powerful air movement (fan, air-conditioning…), by
walking close the bed and by other sources
Increasing the threshold level, it will be harder to sense the baby's movement, while the sensor
pad will be less sensitive in terms of the surrounding vibration.
e.g: if you set the level to:1 then the unit will be the most sensitive,
if you set the level to:9 then it will be the less sensitive.
The default sensitivity (threshold) level is: 3