User Manual

9
Troubleshooting
The Camera, Monitor and Movement Unit have all been paired at the factory.
If any of the components need to be re-paired, please see below:
If the Camera is disconnected from the power source while Movement Unit is in
charging station, please power OFF the Movement Unit to avoid an alarm.
To Re-Pair the Camera and Monitor:
®
1
Place the Monitor
and Camera within 3
feet of each other and
power on both units.
3ft
®
100%
menu left/right
ok
2
Pause Icon – Pressing the Pause
button on the Monitor when the Alarm
Icon is on the screen and the Monitor
is alarming will silence the Alarm for
15 seconds. After 15 seconds, if there is
still no movement detected, the alarm
will resume. Note: The alarm can also
be paused if there is any movement
of the Movement Unit.
Alarm Icon – After no movement has
been detected for 15 seconds, the
Monitor will begin to beep. After 20
seconds of no movement detected,
the Alarm icon will appear on the
Monitor screen and the Monitor will
beep rapidly.
®
PRESS PAUSE BUTTON
AND CHECK MOVEMENT
®
Paused
100%
pause alarm
beep
®
100%
Pairing
3
You should see the PAIRING
SCREEN that will appear for
20 seconds.
Press the MENU button on the
Monitor and use the RIGHT or
LEFT button to move to the CAMERA
icon. Press the OK button to start pairing.