Instruction manual

O
V
E
R
V
I
E
W
9
Setting Up Your Evolution (Cont.)
D
F
G
E
6. Position the telescopic thread guide.
Raise the telescopic thread guide to its highest position. Rotate the shaft to the left and right until each section
"clicks" into a locked position (fig. D).
7. Thread guide extension
To install: Snap & lower. Place plastic support of thread guide extension on top of main telescopic thread guide.
Support the main guide with one hand and snap the extension guide to the back with your other hand (fig. D).
Lower into position. To remove: Raise & pivot. Raise the plastic support straight up and pivot the back of the
support up to release (fig. E).
8. Opening front cover
The front cover may be opened simply by placing your fingers behind the tab at the right side and pulling toward
you (fig. F).
9. Opening Cutting blade cover
To open the cutting blade cover, place your thumb against the tab, and slide the cover to the right. A slight pull
toward you will allow the cover to swing down, providing access to the loopers, blades, and thread guides
(fig. G).