Instruction manual

1. With the presser foot in the up position, open the front cover and move the threading lever into the thread-
ing position (fig. A page 19).
2. Set the stitch selector lever to "D" position for easy threading of the chain looper tension dial.
3. Place the thread cone or spool on the "Chain Looper" spool pin. Slip the thread into the telescopic antenna
thread guide extension C directly above the spool (fig. C, page19).
4. Insert the thread through the guide above the chain looper tension dial from right to left. Bring the thread to
the back and under the thread guide, then up and over the tension dial (fig.D inset).
5. Put thread into guide on front of dial, then down to the chain looper threading port.
6. Pull 18 inches (45cm) of thread and insert 1/2 inch (1.2cm) of thread into the chain looper threading port. Use
tweezers if necessary, to insert the thread end (fig. E).
7. Push the threading button (fig. E). If the thread does not go through the chain looper eye with one push, push
the threading button again until it does.
8. Open side cover to the left for easy access to the chain looper thread in tray ( fig. F).
9. Trim excess thread to 4 inches (10cm) from the eye of chain looper and leave it hang.
10. Close side cover.
11. Set the threading lever to serging position.
T
H
R
E
A
D
I
N
G
Chain Looper
DE
F
Push to Thread Button
21
Chain Looper
Thread Tray
Side
Cover