Instruction manual

1. Open the front cover and raise the presser foot.
2. At the threading port, clip the looper thread that is to be replaced. (fig.A)
Remove thread from under the foot and the upper thread guides.
Replace cone of thread with specialty thread.
3. With
the threading lever engaged in the threading position (fig. B) turn
handwheel towards you to close looper tubes (fig. C).
4. Thread specialty thread into the upper thread guides, leaving an 18
inch (40cm) tail above the threading port (fig.D).
5. Cut a 24 inch (55cm) strand of serger thread and fold in half to form a
thread cradle. Insert the loose ends of the thread cradle into the port
about 1 inch (2.5cm).
6. Holding the cradle loop with left hand, push the threading button with
your right hand (fig.E) until the thread ends come out the looper eye.
For chain looper, open side door of machine to make sure thread is in
eye of chain looper.
7. Insert the specialty thread tail into the cradle loop (fig.F), pull the serg-
er thread ends until the specialty thread comes through the looper eye
(fig.G). Discard or set aside the thread cradle.
8. Run upper looper thread under the foot and to the left, cut lower loop-
er thread to 4 inches (10cm) and leave it hanging loose. Cut chain loop-
er thread 4inches (10cm) and place in tray. Close side door of machine.
(fig.H)
S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
79
Thread Cradle for Loopers
A
B
C
D
E
F
G
H