Instruction manual

The fixed blade is made of a special long lasting steel and does not require frequent replacement. If neces-
sary, contact your nearest retailer for replacement of the blade.
The upper moving blade is made of a softer steel material and will require replacement. A spare blade is pro-
vided with the machine for replacement if necessary. The spare blade is located in the thread spool stand
accessory compartment.
If for some reason your machine does not cut or perform as it should be, please take your machine to your
nearest Baby Lock retailer. It is possible that the result of poor cutting may indicate other problems.
M
A
I
N
T
E
N
A
N
C
E
85
Replacing Cutting Blades
A
B
TO REPLACE MOVING BLADE proceed as follow;
1. For safety reasons, unplug main power cord.
2. Open front cover and cutting blade cover (fig. A):
3. Remove screw and moving blade (fig. B).
4. Insert new blade into blade slot.
5. Insert screw and place moving blade to its highest position.
6. Hold blade in place and tighten screw.
7. Check and make sure that the top section of cutting blade is set
below the fixed blade when moving blade is in its lowest position.
8. Close cutting blade cover and front cover.
Replacing LED Lighting
Your Baby Lock Evolution is equipped with long-life LED lighting system, which is not necessary to change
bulbs.
In case of replacing LED unit, please contact your authorized Baby Lock dealer.