Owner's Manual

31 32
5.0 FEATURES 5.0 FEATURES
3. If the Harness Straps require
adjustment, remove your child
from the Safety Seat. Rotate
the handle to the upright carry
position (Fig. 31-1).
4. Loosen the harness straps by
depressing the Harness Adjuster
Button located below the ap just
ahead of the Harness Buckle and
pulling on the harness straps.
5. Turn the seat over. Locate the
Belt Adjuster Plate near the
bottom of the seat (Fig. 31-2).
Remove both Harness Straps
from the Belt Adjuster Plate.
From the front of the seat, pull
the Harness Straps through the
shoulder area slots and seat pad.
Fig. 31 -2
Fig.
31 -1
6. Using the included Belt Threading
Tool, insert the Harness Straps
through the Slots selected in step
2 above, in the seat pad and the
seat shell, respectively (Fig. 32-1).
7. From the rear of the Safety Seat,
pull the Harness Straps through
the Slots until you have enough
strap to reach the Belt Adjuster
Plate.
8. Reassemble the Harness Straps
to the Belt Adjuster Plate. Do the
left Harness Strap rst, followed
by the right Harness Strap.
Check that Harness Straps are
completely within the Belt Adjuster
Plate loop (Fig. 32-2). You have
three adjustment positions on the
harness.
Fig. 32-1
Belt Threading Tool
A
B
C
A
B
C
A
B
C
A
B
C
Fig. 32-2