Owner's Manual

49 50
7.0 INSTALLATION 7.0 INSTALLATION
7. Check that nothing is on top of the base or anything that will
interfere with the proper latching of the Safety Seat to the Base.
Place the Safety Seat onto the Base and push down until the Safety
Seat latches securely to the Base and you hear a click. Pull upward
on the Safety Seat to check that the Safety Seat is securely latched
onto the base (Fig. 24-1).
If the Safety Seat does not securely latch onto the Base, the Safety
Seat will provide No Protection for your child. DO NOT use the
Safety Seat with the Base if it does not securely latch onto the Base.
Please call Baby Trend at 1-800-328-7363 for assistance.
A
B
Press to
release
Fig. 49-1
8. To remove the base from the
vehicle, squeeze the webbing
release button on the LATCH
connector to loosen the
webbing (Fig. 49-1a).
NOTE: The LATCH connector
can not be released from the
LATCH anchor if the webbing
is tight. Press the LATCH
hook release button on each
connector to release the
connector from the anchor
(Fig. 49-1b).
7.4 Setting Proper Recline of the
Safety Seat / Base
For your child’s safety, the
Safety Seat must be properly
reclined when installed in
the vehicle. The Safety Seat
includes a Seat Angle Indicator
on the lower portion of the shell
on the child’s left side, to assist
in achieving the proper angle
of recline for the Safety Seat
(Fig. 50-1).
Use weight range as appropriate
See warning label on safety seat
Fig. 50-1
Failure to properly recline the Safety Seat on the vehicle
seat increases the risk of death or serious injury. If the Safety
Seat is positioned too upright, the child’s head may drop
forward and result in breathing problems. If the Safety Seat
is too reclined, excessive force may be exerted on the child’s
shoulders and neck in a crash. The following instructions
must be carefully followed to ensure proper recline angle for
the Safety Seat.
WARNING
Center