Owner's Manual

9.0 ADD’L INFORMATION

8.0 FINAL CHECKS

FINAL SAFETY CHECKS

8.1 Checking Safety Safety

1. If your child is already in the Safety Seat, check that the

harness is properly tted and tight as instructed in the section

6.1, Securing your Child in the Safety Seat / Carrier.

2. Make sure that the Safety Seat is tightly installed and secure

in the vehicle by performing the following test every time you

use the Safety Seat. Firmly push down and side to side on

the head end of the Safety Seat to make sure that the vehicle

seat belt does not loosen at all and that the vehicle seat belt is

fastened very tightly around the Safety Seat / Base. If you nd

that the vehicle seat belt loosens or that the seat easily moves

or rotates downward, please see section entitled Selecting the

Best Location for the Safety Seat to determine if the position

you have selected is adequate and check that you have

completed all of the steps in the section entitled Securing the

Safety Seat or Base in the Vehicle.

DO NOT use this seating location if the Safety Seat does not

remain tightly installed in the vehicle seat!

3. Remove any toys or other objects attached to carry handle

4. Adjust carry handle into desired adjustment position.

ADDITIONAL INFORMATION

9.1 Using the Safety Seat in an Airplane

This Safety Seat may be used without the Base in an airplane in

the same manner as it is used in an automobile. Please check

with the airline in advance to determine their policies regarding

the use of Safety Seats aboard the airplane. The Safety Seat

must be used in only a forward facing airplane seat. Please ask

the ight attendant for assistance in placement of the Safety

Seat. Please follow these instructions for proper installation and

perform the Final Safety Check as instructed herein.

9.2 Using your Baby Trend Safety Seat with a

BabyTrend Stroller

Please see the stroller owner’s manual for information on the use

of the Safety Seat with the Baby Trend stroller.

9.3 Cleaning and Maintenance

The hard surfaces of the Safety Seat, (plastic components and

metal parts). May be cleaned by wiping with a solution of water

with mild soap. DO NOT use bleach as it may weaken plastic

components. Dry all surfaces with a clean towel.

The Harness Straps may be spot cleaned with a solution of mild

soap and water or may be replaced if they become overly soiled.

DO NOT launder the straps as they may become damaged or

weakened. Please contact Baby Trend customer service to order

replacement harness straps.