Owner's manual

11
12
OPERATION OPERATION
Copyright © 2018, Baby Trend
®
Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2018, Baby Trend
®
Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO REATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
19) • Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 19). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are rmly in place.
20) • Loop the ap on the back of the pad
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These t over the
Attachment Tabs located near the top
harness slots (Fig. 20a).
• Insert the Harness Covers through the
Harness Straps (Fig. 20b).
TO FOLD HIGH CHAIR
The High Chair may be folded with the seat in
any of the height positions.
15) • Place seat in the desired height position.
Place Seat Back in the most upright
position (Fig. 15).
16) • Squeeze the tray release handle and
slide the tray out (Fig. 16).
17) • Hang the tray on the hooks located on
the back of the rear leg (Fig. 17).
18) • Pull upward on the release levers
(located on the sides of the frame) and
push the rear legs in the direction of the
front legs until folded (Fig. 18). Chair is
now ready to put away.
DO NOT allow your child to play around
a folded high chair as it may fall.
TO UNFOLD HIGH CHAIR
Read the Warning and see (Fig. 18), then
Reverse the steps above.
WARNING: Do not sit
on the frame when the seat is
not attached. Do not use frame
as a foot stool. Potential pinch
point when opening the frame.
Fig. 15
Fig.17
Tray Release located underneath tray
Fig. 18
Fig. 16
Fig. 19
Fig. 20b
Fig. 20a
DO NOT place
ngers here.