Operation Manual

14
BabyGO • www.babygo.eu
BabyGO
Baby car seat
TravelXP
9. Pull the shoulder belts tight using the quick
adjuster belt strap on the front. The loop can
be secured under shell rim.
10. Adjust the height of the shoulder belts, the
shoulder belts should run through the slots
located directly above the baby‘s shoulders
as shown in picture 10.
• Pull the shoulder belts through the slots in
the shell and cover
• Place the shoulder belts back, at the requi-
red height and use the same slots in both
shell and cover. Check to make sure the
belts can be used properly and that they are
not twisted.
11. Press the buttons on both sides of the carry-
ing handle at the same time end then adjust
the carrying handle to the desired position.
The buttons will pop up again once the handle
is in place. 1. carrying position/driving positi-
on 2. sleeping position/rocking position 3. sit-
ting position as shown in picture 11. Removing
the cover.
12. First remove the belt pads, open the rim at the
sun canopy as far as possible. Then pull the
buckle tongue sections and adjustment strap
through the openings. To refi t the cover, carry
out the above instructions in reverse order.
Maintenance
• The seat can be cleaned with soap and lukewarm water. Do not use any abrasive detergents.
• The cover must be washed by hand (maximum 30 C) . Do not use a dryer.
• The belt buckle can be cleaned using warm water. Do not lubricate.
• To ensure optimum and safe use of car safety seats, they should not be used for longer than 5 years
after the date of purchases. Ageing of the plastic, for instance, under the infl uence of sunlight (UV),
may quite unnoticeably reduce the qualities of the product.
• Once the child has grown out of the seat we therefore advise you to no longer use the car seat and
to dispose of it in proper way.