User Manual

INSTRUCTIONS FOR USE
• Ensure the hair is 80% dry and combed through to remove any
tangles. Divide the hair into sections ready for styling.
• Secure the selected attachment onto the handle. To interchange
between the attachments, refer to the ‘Changing the Attachments’
section.
• Slide the switch to the heat setting suitable for your hair type to turn
the appliance on.
• After use, slide the switch to the ‘0’ position to switch off and unplug
the appliance.
• Allow the appliance to cool before storing away.
Changing the Attachments
• Place the attachment onto the handle and line up the two indents
with the buttons on the handle.
• Push the attachment onto the handle until it clicks into place.
• To remove an attachment, press and hold the two buttons on the
side of the appliance and pull the attachment away from the handle.
Drying Nozzle Attachment
• Use the drying nozzle attachment to remove excess moisture pre-
styling by directing the airow onto the hair and moving the airstyler
around the head.
50mm Volumising Brush Attachment
• Place the brush head underneath a section of hair, close to the scalp
and hold for a few seconds to boost volume at the roots.
• Use the brush head to lift the hair at the roots as you dry.
• Slowly move the brush head down through the hair, as you reach the
end of the hair section, rotate the airstyler slightly towards your face
to curl the ends under.
• For a lasting style, select the cool setting ‘*’ on warm hair whilst
holding the brush head at the roots.
• Repeat for each section of hair.