User's Manual

10
11. Technical Data
10. Troubleshooting
Possible cause(s)
Cannot hear the baby sounds
on the Parent Unit
• Volume setting on the Parent Unit may be too low. Increase the volume.
Background noises • In a quiet environment surrounding the Parent Unit, decrease the
volume on your Parent Unit to level 3 and below.
• In a loud environment surrounding the Parent Unit, increase the
volume on your Parent Unit to the maximum level.
Problem
No reception on the Parent Unit
Interference or poor reception
• The power adapters may not be properly connected.
• Ensure that the Baby and Parent Units are ON.
• Make sure the Baby Unit and Parent Unit are not far away from each other.
• Baby Unit and Parent Unit may not be properly paired. Follow
PAIRING instructions.
• Move the Baby Unit closer to Parent Unit.
• The Baby or Parent Units may be too close to metal objects.
• Other electronic devices may be interfering with the signal.
• The battery power may be too low.
Image frozen on the Parent Unit
A high pitched ear piercing
noise is heard from the units
(feedback, static)
• Restart the Baby Unit (pull out the power adapter from the wall
outlet, wait for approx. 5 seconds and plug it back in).
• Reset the Parent unit by opening the battery compartment and
disconnecting the battery. Wait for 30 seconds and then reconnect
the battery.
• The Baby Unit and Parent Unit may be too close to each other. Move them
further apart.
• The volume on the Parent Unit may be set too high.
Frequency
Operating Range
Power Adapter
LCD Screen
Rechargeable battery (pre-installed in
Parent Unit)
Operating time with battery fully charged
(Parent Unit)
2.4GHz FHSS
Up to 960 feet (open space)
Input: 240-100VAC 60 / 50Hz, 200mA Max;
Output: 5V, 700mA;
2.4” TFT LCD
Model: YB 503450
3.7V, 950 mAh, 3.515Wh
Approx. up to 10 hours (ECO on)
Image sensor type 1/6.5 " Color CMOS
IR LED Type 940nm
Operation Environment Indoor use only; Temperature: 32-104 °F
Humidity: 5% to 90% rh. (relative humidity)