Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE.
WARNINGS WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference. WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the seat belt and insure that the child is properly positioned according to these instructions. WARNING: Never leave child unattended.
PARTS Rear Axle Base Child Tray Locking Cap Rear Wheels Hub Cap Parent Tray Car Seat Seat Car Stroller Front Wheels Front Wheels Solid Cap TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. TO ASSEMBLE STROLLER * Remove stroller from box. The front wheels, rear wheels, child tray, and parent tray need to be installed prior to use. * To attach the front wheels, unfold stroller as described in the section following.
* To attach the front child tray, push the angled tray onto the post at the end of right armrest, while pressing downward on the snap button, until locked into place. Please see figure 5. Rotate the tray downward until latched onto the left armrest. Please check that the snap button comes through and securely latches the tray in place. Please see figure 6. * To remove front child tray, press inward on the left side tray release button and rotate upward on the tray. Please see figure 7.
TO SECURE THE CHILD * Carefully place the child in the stroller seat and bring the seat belt around the child’s waist. Place the crotch strap between the child’s legs. Insert the male end of each waist belt into the buckle on the crotch strap. Tighten the seat belt to be snug around the child’s waist. Please see figure 14. Figure 14. WARNING: Avoid serious injury from falling or sliding out. Always use the seat belt. * To release, apply pressure to both sides of each male clip until the clip is released.
FRONT CHILD / CAR SEAT TRAY COVER * The cover of the child/car seat tray may be fastened in the closed position after your child outgrows the infant car seat. This will prevent an older child from opening the child tray. To secure the tray cover, remove the tray from the stroller as shown in the to remove front child tray section. Install the tray cover. Place the tray with the lid side down on a soft flat surface. Remove the screw stored under the tray as shown in figure 21.
CANOPY * To open the canopy, push forward on the front frame of the canopy. To close canopy, pull the front edge toward the rear of the stroller until folded. Always fold the canopy prior to folding the stroller frame. Please see figure 25. Front frame tube Figure 25. TO REMOVE FRONT CHILD TRAY * To remove front child tray, press inward on the tray release button on the left armrest and pull up on the tray. Please see figure 7.
TO FOLD STROLLER * Close the canopy as described in the Canopy section above. Place seat back in fully reclined position by unbuckling recline strap. Pull stroller backward several inches to rotate the front wheels to the front. Please see figure 28. To fold the stroller slide the red fold lock with your thumb while squeezing the large red fold button in the center of the handle and push downward on the handle.
CLEANING SEAT PAD * The seat pad may be removed for washing. To remove the seat pad, unsnap the two straps on the rear of the seat as shown in figure 33. Unfasten the seat belt and pull the waist belts and crotch strap through the cutouts in the pad as shown in figure 34. Pull downward on the front edge of the seat pad to remove from the stroller as shown in figure 35. Please see the care label on the rear of the seat for washing instructions. To re-install the pad, follow these instructions in reverse order.