Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. Model #8166BC SAFAri babies Trend Nursery Center Instruction Manual Convenience through Innovation and thoughtful design 08.
SAFAri babies Trend Nursery Center Read all instructions BEFORE assembly and USE of Playard. KEEP INSTRUCTIONS FOR FUTURE USE. WARNING: FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH FROM ENTRAPMENT, STRANGULATION, SUFFOCATION, ETC. WARNING: INFANTS CAN SUFFOCATE: IN GAPS BETWEEN A MATTRESS TOO SMALL OR TOO THICK AND PRODUCT SIDES, ON SOFT BEDDING. NEVER ADD A MATTRESS, PILLOW, COMFORTER, OR PADDING.
FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE INSTRUCTIONS COMPLETELY BEFORE ASSEMBLING THE PLAYARD, BASSINET AND CHANGING AREA TO ASSEMBLE PLAYARD CONTENTS (Fig. 1-1): 1 1 2 2 1 Playard Mattress Leg extensions (1 Left,1 Right) Leg extensions with wheels (1 Left, 1 Right) Travel or Storage bag Figure 1-1. BEFORE YOU BEGIN: The Baby Trend Playard is designed so that, when properly setup, the fabric of the playard places pressure on the 4 top rails making them nearly impossible to unlock.
WARNING: All top rails MUST be straight and locked in position or child may become entrapped and suffocate. See figure 9 and 10. 5. Place mattress in Playard with padded side up (Fig. 11). NOTE: DO NOT insert mattress if using bassinet feature. Go to bassinet instructions. 6. Left Figure 4 Right Feed the 6 hook and loop straps (found underneath the mattress), 3 on each end of the mattress pad, through the slots on the bottom of the sides of the Playard.
FOLDING PLAYARD 1. Undo the 6 hook and loop straps holding mattress from underneath Playard floor. (If mattress is not used in the bassinet). Remove mattress and set aside. 2. Grasp the center floor lock handle pushing down. Rotate the handle counter-clockwise about 90 degrees and lift upward until handle is as high as the top rails. Gather the four feet of the playard together so that they nearly touch each other. See figures 1 and 2.
PLAYARD BASSINET/CHANGING AREA WARNING:FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH FROM ENTRAPMENT, STRANGULATION, SUFFOCATION, ETC. • To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their back to sleep, unless otherwise advised by your physician. • Always provide the supervision necessary for the continued safety of your child. When used for playing, never leave child unattended.
TO ASSEMBLE YOUR BASSINET NOTE: Playard MUST be in a locked set-up position before installing and using the bassinet feature. CONTENTS (Fig. 1): 1 Nylon bassinet insert 4 Metal support tubes 2 (male) (2 female) ASSEMBLY 1. Insert the 2 female tubes into the two male tubes. (Fig. 2) 2. Insert the 2 assembled tubes through the loops provided on the bassinet insert. (Fig. 3). 3. Place assembled bassinet onto the Playard. Push down each of the bassinet supports onto the playard frame as shown in (Fig. 4).
TO ASSEMBLE CHANGING AREA CONTENTS (Fig. 1): • • • 2 Long curved bars 2 Short bars with connector knobs 1 Changing area fabric WARNING: • • • • • Figure 1 Avoid serious injury or death: Always use restraint belt to prevent falls Use changer with infant who’s weight is less than 18 lbs (8.2 kg ) and is less than 25 inches (63.5 cm) tall. Discontinue use of changer if infant can push up on hands and knees or sit unassisted. DO NOT carry changer with infant in it.
NOTE: Short bar with connector knobs should be facing inward. 5. Place connector knob prongs into holes located on corner pieces of Playard (Fig. 5). 6. Turn connector knobs counter clockwise to lock (Fig. 6). 7. Flip changing area to inside of Playard (Fig.7). 8. Snap flap from changing area to side of Playard (Fig. 8). 9 Check that changing area is secure before using. Figure 5. Figure 6. Figure 7. Figure 8. REMOVAL AND FOLDING CHANGING AREA REMOVAL 1. Flip changing area to the outside of the Playard.
HOW TO USE CHANGING TABLE RESTRAINT 1. Place child on changing table, make sure hands and arms are clear of the restraint. Bring the restraint around the child's waist and clip the male and female ends of the buckle together. See Fig 1 2. Tighten strap until fits snug around child's waist. DO NOT OVER TIGHTEN. See Fig. 2 3. To remove un snap the buckle. Fig. 1 Fig.
REMOVAL OF BASSINET REMOVAL 1. Remove mattress from bassinet (Fig.1). 2. Lift bassinet out of Playard (Fig. 2). The bassinet is now ready for storage. NOTE: Store bassinet and changing area with folded Play yard in carry bag. Figure 1 Figure 2 TO INSTALL TOY BAR 1. Attach the toy bar to each end of the playard opposite of the changing table. Clip the plastic hooks onto the top rails of the play yard. (Fig. 3.) WARNING: This toy bar is designed to be used from birth to 5 months.