Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. Model #8206BCC DELUXE TREND NURSERY CENTER Instruction Manual Convenience through Innovation and thoughtful design 01.
Trend Nursery Center Read all instructions BEFORE assembly and 01.06 USE of Playard. KEEP INSTRUCTIONS FOR FUTURE USE. WARNING: FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH FROM ENTRAPMENT, STRANGULATION, SUFFOCATION, ETC. WARNING: INFANTS CAN SUFFOCATE: IN GAPS BETWEEN A MATTRESS TOO SMALL OR TOO THICK AND PRODUCT SIDES, ON SOFT BEDDING. NEVER ADD A MATTRESS, PILLOW, COMFORTER, OR PADDING. USE ONLY THE MATTRESS PROVIDED BY MANUFACTURER.
FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE INSTRUCTIONS COMPLETELY BEFORE ASSEMBLING THE PLAYARD, BASSINET AND CHANGING AREA TO ASSEMBLE PLAYARD CONTENTS (Fig. 1-1): 1 1 1 2 2 1 Playard Mattress Organizer Leg extensions (1 Left,1 Right) Leg extensions (1 Left, 1 Right) with Wheels, and hardware Travel or Storage bag BEFORE YOU BEGIN: The Baby Trend Playard is designed so that, when properly setup, the fabric of the playard places pressure on the 4 top rails making them nearly impossible to unlock.
WARNING: All top rails MUST be straight and locked in position or child may become entrapped and suffocate. See figure 9 and 10. 5. Place mattress in Playard with padded side up (Fig. 11). Left NOTE: DO NOT insert mattress if using bassinet feature. Go to bassinet instructions. 6. Feed the 3 hook and loop straps (found underneath the mattress), through the slots on the bottom of the sides of the Playard. Fasten the hook and loop straps to the underside of Playard to prevent the mattress from moving (Fig.
FOLDING PLAYARD 1. Undo the 3 hook and loop straps holding mattress from underneath Playard floor. (If mattress is not used in the bassinet). Remove mattress and set aside. 2. Grasp the center floor strap and lift upward until handle is as high as the top rails. Gather the four feet of the playard together so that they nearly touch each other. See figure 1 and 2. NOTE: TOP RAILS OF THE PLAYARD ARE STILL IN THE “LOCKED” POSITION. Pull Up Figure 1 3.
PLAYARD BASSINET/CHANGING AREA 01.06 WARNING:FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH FROM ENTRAPMENT, STRANGULATION, SUFFOCATION, ETC. • To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their back to sleep, unless otherwise advised by your physician. • Always provide the supervision necessary for the continued safety of your child. When used for playing, never leave child unattended.
TO ASSEMBLE YOUR BASSINET NOTE: Playard MUST be in a locked set-up position before installing and using the bassinet feature. CONTENTS: 1 Nylon Bassinet Insert ASSEMBLY NOTE: The printed warning label should be facing toward the inside of the bassinet so that it is readable. The bassinet is oriented with the canopy opposite from the changing area. 1. The top corner pieces of the playard with slots as shown in (Fig. 1) is the changing area end.
TO ASSEMBLE CHANGING AREA CONTENTS (Fig. 1): • • • 2 Long curved bars 2 Short bars with connector knobs 1 Changing area fabric WARNING: • • • • • Figure 1 Avoid serious injury or death: Always use restraint belt to prevent falls Use changer with infant who’s weight is less than 18 lbs (8.2 kg ) and is less than 25 inches (63.5 cm) tall. Discontinue use of changer if infant can push up on hands and knees or sit unassisted. DO NOT carry changer with infant in it.
NOTE: Short bar with connector knobs should be facing inward. 5. Place connector knob prongs into holes located on corner pieces of Playard (Fig. 5). 6. Turn connector knobs counter clockwise to lock (Fig. 6). 7. Flip changing area to inside of Playard (Fig.7). 8. Snap flap from changing area to side of Playard (Fig. 8). 9 Check that changing area is secure before using. Figure 5. Figure 6. Figure 7. Figure 8. REMOVAL AND FOLDING CHANGING AREA REMOVAL 1. Flip changing area to the outside of the Playard.
REMOVAL OF BASSINET REMOVAL OF BASSINET 1. Remove mattress from bassinet (Fig.1). 2. Remove canopy (Fig. 2). 3. Un snap all clips and lift bassinet out of playard (Fig. 3) The bassinet is now ready for storage. NOTE: Store bassinet and changing area with folded Playard in carry bag. Figure 1 Figure 3 Figure 2 TO REMOVE CANOPY REMOVAL OF CANOPY To remove the bassinet canopy, pull upward on the ends of the canopy from the side of the playard. The canopy can be stored in the travel bag.
MUSIC CENTER The music center is designed to be attached to the playard as shown in figure 1. attach attachhere here MUSIC OPERATION The music center requires 4 AA batteries. Please see figure 2 for battery installation. Unscrew the battery door screws and pull outward on the battery door. Install batteries as shown. Re-install play battery door and secure with screws. rec Figure 1 play vol prev ON To active the unit, press the on/off button.