Instruction Manual

ManualsBrandsBabywise ManualsAuto & DIY2-in-1 Booster Car Seat

2 in 1 Booster Seat

INSTRUCTIONS FOR USE

GROUP II+III

Suitable for children weighing 15kg to 36kg

Notice

This is a “Universal” child restraint. It is approved to the EU Regulation

vehicle’s handbook that the vehicle is capable of accepting a Universal

child restraint for this group.

conditions than those which applied to earlier designs which do not

carry this notice.

If in doubt, consult either the child restraint manufacturer or the

retailer.

safety-belts, approved to UN/ECE Regulation No. 16 or other

equivalent standards.

No. 44, 04 series of amendments, for general use in vehicles and it will

Summary of content (12 pages)

PAGE 1
® 2 in 1 Booster Seat INSTRUCTIONS FOR USE GROUP II+III Suitable for children weighing 15kg to 36kg Notice 1. This is a “Universal” child restraint. It is approved to the EU Regulation No. 44, 04 series of amendments, for general use in vehicles and it will 2. 3. vehicle’s handbook that the vehicle is capable of accepting a Universal child restraint for this group. conditions than those which applied to earlier designs which do not carry this notice. 4.
PAGE 2
Contents 1. Applicability 3 2. Safety Instructions 4 3. Parts and interior equipment 5 4. 4.1 Usage for age (group II & III) Height adjustment of head rest 6 6 4.2 4.3 4.4 Booster Seat with Backrest (15-36kg child) Booster Seat without Backrest (22-36kg child) Securing the child car seat with vehicle’s belt 7 7 8 5. 5.1 5.2 5.3 Care instructions Removing/ replacing the cover Cleaning the cover Care and maintenance 11 11 11 12 6.
PAGE 3
NOTES Please read through these instructions carefully before using the if you use the product incorrectly. 1. Applicability: This child car seat is suitable for weight categories II to III (Group II, III), which means children with a body weight between 15kg and 36kg. Mass Group II: Mass Group III: 15kg - 25kg 22kg - 36kg safety-belts, approved to UN/ECE Regulation No. 16 or other equivalent standards.
PAGE 4
PAGE 5
3.
PAGE 6
Upper Belt Guide Lower Belt Guide On the underside of the seat base, there is a clip in cup. This may be popped out for use. It can be snapped into the rectangular socket on either side of the seat for use. 4. Usage for Groups II and III Only the 3-point vehicle belt system can be used to buckle up the child car seat. 4.1 Height adjustment of head rest Regularly check whether the headrest is set optimally to your child.
PAGE 7
4.2 4.
PAGE 8
4.4 Securing the child car seat with 3-point vehicle seat belt in booster with back The vehicle’s 3-point belt system may only be used to buckle up children of Groups II and III (15kg - 36kg). Step 1: Place the child safety seat on the vehicle’s seat ensuring Step 2. Seat your child in the child car seat (Fig 3.) Fig. 2 Fig. 3 Step 3: Pull out the 3-point safety belt of the vehicle and place the lap belt through the Lower Belt Guide (Fig 4.
PAGE 9
Step 4: Place the diagonal belt through the Upper Belt Guide (red hook) at the side of the headrest and ensure it is fully retained by the hook. Check and make sure the belt is not twisted (Fig 7.) Please make sure the position of the safety-belt is not near the throat to avoid any risk of strangling. RP SSE SS E RP The correct location of the adult safety-belt buckle relative to the child car seat is as shown in Fig 6. Fig 6. Fig 7. This seat can also be used with the base only.
PAGE 10
Secure Child Properly in Booster 22-36kg vehicle belt not twisted vehicle lap belt under arm rests vehicle shoulder belt over arm rest Installation in vehicle Step 1: aside. Step 2: Put the booster on a forward facing-facing vehicle seat. Step 3: Have child sit on booster seat so their back contacts vehicle seat from shoulders to bottom. Step 4: Position vehicle belt over child.
PAGE 11
5. Daily Caring Instructions 5.1 To remove the cover Step 1: seat to the horizontal position (Fig 8). Step 2: Unhook and disconnect the seat and back. Step 3: Unsnap the studs at the bottom rear of the back cover and Step 4: Remove the headrest cover by unsnapping the stud at the bottom front and pulling the back edge of the cover up over the top.
PAGE 12
5.3 Care and maintenance It is necessary to check the functions and components of the child car seat periodically according to these instructions in order to avoid any accidents. pulling on the safety belt. Avoiding storing the child car seat in damp or cold locations for long periods. 6. Procedure after accident The child car seat must be replaced when it has been subject to violent stresses in an accident. Do not continue to use, as there may be hidden damage or weaknesses caused by the accident.