Instruction Manual

ManualsBrandsBabywise ManualsBaby & ToddlerFlat Fold High Chair Multi-Coloured

Flat Fold Highchair

INSTRUCTION MANUAL

Designed and manufactured to BS EN 14988: 2012

IMPORTANT:

Thank you for choosing our product. Please read and understand these instructions before using this flat fold

highchair. If in doubt, please seek help from our Customer Service Team.

Please retain the instructions for future reference.

Images in this manual are representative only. Actual product may vary. The manufacturer reserves the right to change specifications

without prior notice.

Summary of content (7 pages)

PAGE 1
Flat Fold Highchair INSTRUCTION MANUAL Designed and manufactured to BS EN 14988: 2012 IMPORTANT: Thank you for choosing our product. Please read and understand these instructions before using this flat fold highchair. If in doubt, please seek help from our Customer Service Team. Please retain the instructions for future reference. Images in this manual are representative only. Actual product may vary. The manufacturer reserves the right to change specifications without prior notice.
PAGE 2
SAFETY THANK YOU FOR CHOOSING OUR PRODUCT. PLEASE TAKE TIME TO READ THE IMPORTANT SAFETY NOTES BELOW. THIS WILL ENSURE MANY YEARS OF HAPPY AND SAFE USE. WARNING: WARNING! Do not use the highchair until your child can sit up unaided (6-36 months). WARNING! Do not leave the child unattended. WARNING! Ensure your child wears a correctly fitted and adjusted harness at all times. WARNING! Do not use the highchair unless all components are correctly fitted and adjusted.
PAGE 3
PARTS Please retain all packaging until you are certain that no parts are missing. After assembly, please dispose of all packaging carefully, including the protective foam on the ends of the leg tubes. Tube Connections: The Legs and the Seat Frame connect using the system shown. Push in button A, insert the end of the seat tube into the leg tube and slide down until the button appears in the corresponding hole B in the leg tube and clicks into place.
PAGE 4
FIT THE SEAT Fit the semi-circular back tube to the seat frame, clicking the legs into place as shown in the previous drawing. Open the seat frame. Slide the pocket on the back of the seat cover down over the tube back frame. Fasten the press stud on each side of the seat to the inside of the tray pivot - A. Pull the front of each side of the seat cover around the front of the frame and fasten the two press studs on each side of the seat to the tube - B.
PAGE 5
ATTACHING AND CHECKING THE HARNESS The harness comes fitted to the seat, but needs to be checked and adjusted before use. The shoulder straps are pre-fitted to the seat back tubes. Pull them fully out through the slots in the seat cover after the cover is fitted. They can be adjusted only for tightness, using the slide adjusters. Ensure the waist straps and crotch strap are fed through the slots in the seat cover and are correctly fitted to the chair frame.
PAGE 6
FOLDING Release the press stud on the webbing strap underneath the tray, lift the tray firmly to release the clips from the tube, and fold the legs together.
PAGE 7
MAINTENANCE    Ensure all locking devices work correctly and regularly check the locks and fittings for security. Regularly check all parts for wear and tear. Do not use spray lubricants, simply wipe clean after use. CARE     Clean spills as soon as possible to prevent permanent marking. The highchair can be cleaned by sponging with warm soapy water and a mild detergent. A mild disinfectant may be used if desired. Stubborn marks may be removed with a non-abrasive cleaner.