Instruction Manual

12
Model number PPS1CWE Contact us / 1-877-571-2391
• Increase the separation between the equipment and any other radio device.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
SPECIFICATIONS
Boost Ampere: 1,000A peak, 350A instant
Battery Type: SLA, 12V DC
Input: 120V AC, 60Hz, 14W
Compressor: 120 PSI (max.)
USB Output: 5V DC each, 3.1A (max.)
Wireless Charging: 15W (max.)
Sure Fit
®
is a registered trademark owned by Baccus Global, LLC.
Imported by Baccus Global LLC, 621 NW 53rd St., Suite 450, Boca Raton, FL 33487
www.Baccusglobal.com 1-877-571-2391
RD051821
Número de Catálogo PPS1CWE
Ayuda
¿Preguntas?
Llame a la línea directa de atención al cliente
1-877-571-2391
PUENTE AUXILIAR DE ARRANQUE
DE 1000A CON CARGA INALÁMBRICA
CONSERVE ESTE MANUAL PARA FUTURAS CONSULTAS.
Derechos Reservados © 2021 Baccus Global LLC
Boca Raton, FL 33487 1-877-571-2391
PPS1CWE_ManualENSP_051821.indd 12-13PPS1CWE_ManualENSP_051821.indd 12-13 5/18/2021 3:42:06 PM5/18/2021 3:42:06 PM
FCC Statement
This device complies with part 18 of the FCC Rules. Operation is Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user's authority to
operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 18 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15
cm surrounding the device and 20 cm above the top surface of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
● Increase the separation between the equipment and any other radio device.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ISED Statement
This device complies with Industry Canada’s license-exempt RSS. Operation is subject to the following two conditions:
● This device may not cause interference; and
● This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est
conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
● l’appareil ne doit pas produire de brouillage;
● l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
RF Exposure Information
This equipment complies with IC RSS-216 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 10cm between the radiator and your body.
Informations sur l' exposition aux RF
Cet équipement respecte les limites d'exposition aux rayonnements IC
RSS-216 fixées pour un environnement non contrôlé.Cet équipement doit être installé et exploité à une distance minimale de 10cm entre le
radiateur et votre corps.