Specifications

Analyzer 2825/2830/2835

8 Instruction 19-9320

2.9 Battery Low Display

When the battery nears depletion, the display will alternate between its

normal display and the following “BattLow” display.

In addition, the beeper will emit three rapid notes every 30 seconds. At

this time the analyzer should be given a full charge per Section 3.6 as

soon as possible.

2.10 Battery Charge Display

An indication of the battery’s charge is obtained by pressing the f

button

once. A bar graph in the lower part of this screen shows an approxima-

tion of the battery’s remaining charge. As the charge reduces, the bar

graph decreases in size. Typical operating time from a full charge is ap-

proximately 10 hours.

2.11 Fault Condition Warning

The analyzer is capable of alerting the operator of an internal fault

condition (i.e., a sensor failure or blockage in the infrared path). If a fault

occurs, the analyzer’s beeper will sound continuously, and the following

message is displayed until the analyzer is turned off.

If the fault warning is displayed at any time, then the analyzer must be

returned to a Bacharach Service Center for repair (refer to Section 4.2).

FAULT

= represents low charge= represents full charge

Battery

Level

BattLow

340