Specifications

CO
2
Analyzer 2825/2830/2835
4 Instruction 19-9320
2.3 Probe Installation (2830 / 2835)
Figure 3. Temperature &
Humidity Probe Installation
Figure 2. Temperature
Probe Installation
2.3.1 Temperature Probe
Installation (2830)
The 2030 Analyzer’s temperature sensor
is mounted in a hand-held probe assem-
bly that plugs into a separate socket on
top of the analyzer (Figure 2).
Before installing the probe, turn the an-
alyzer OFF. Align the slot on the probe
connector with the tab on the analyzer’s
mating socket; then push the probe con-
nector onto its socket until it bottoms.
Remove the probe connector by pulling
it straight up.
2.3.2 Temperature & Humidity
Probe Installation (2835)
The 2835 Analyzer’s temperature and
humidity sensors are mounted in a rigid
probe assembly that attaches to a sepa-
rate connector on top of the analyzer
(Figure 3).
Before installing the probe, turn the
analyzer OFF. Turn the probe’s locking
collar on the analyzer so that all dots
line up. Align the dot on the probe with
the dots on the locking collar; then push
the probe into its socket until it bottoms.
Now lock the probe into place by turning
the locking collar to its locked position.
To remove the probe, rst turn the locking collar to its unlocked position;
then pull the probe straight up.