Combustion Gas Analyzer Operation & Maintenance

Instruction 24-9460
30
Fyrite
®
INSIGHT
Instruction 24-9460
31
Fyrite
®
INSIGHT
4.14 Printing Test Data
Combustion, pressure, or temperature data that is currently being dis-
played can be sent to a printer using IrDA protocol as described below.
Data that is stored in memory can also be printed by first displaying the
stored test data as described in Section 4.13.
In addition to printing combustion, pressure, and temperature data, the
contents of any screen that shows the label “PRINT” above the F1 button
can be printed. For example, the information shown in the DIAGNOSTIC
screen can be printed.
1. Power up the printer.
Refer to the printer’s
instruction manual for
detailed operating infor-
mation. If not previously
done, select the follow-
ing for the printer for:
• 8 bit
• No parity
• 9600 baud
• IrDA is set to
IrDA-SIR
• DTR
handshaking
2. Align the printer with
the top of the analyzer.
3. Press the PRINT (F1)
button to begin print-
ing.
4.15 Fyrite
®
User Software Installation
Windows XP Operating System
After the CD is loaded, the Setup window will be displayed. Click on OK.
(If applicable, wait for the Net 3.5 Framework set up to complete.)
Click "Next" on the “Welcome” screen to begin the installation.
Respond to the prompts on the screens that follow.
Click on: “Finish”...
“Next”...
“Close”...
“OK”...
After the installation,
• Open Fyrite
®
User Software via the desktop icon.
• Connect the instrument to the PC with a USB cable and power up the
unit.
F1
F2
F3
ESC
RUN
HOLD
PWR
BACHARACH, INC.
Fyrite Insight
SN: ENGR-CM03
Time: 01:28:27 PM
Date: 10/22/08
Fuel
Nat Gas
O
2
4.0 %
CO 12 ppm
Eff 82.6 %
CO
2
9.5 %
T-STK 374
o
F
T-AIR 68.0
o
F
EA 21.3 %
CO (3) 13 ppm
Comments:
Fig. 4.2