Specifications

Instruction 0024-9460 14
Fyrite
®
INSIGHT
3.5.5 O
2
Reference
The measured value of CO can be referenced to a specific O
2
percentage of
0% to 15%. Set up the reference value as follows:
1. Enter the Setup Menu per Section 3.5.1. If
necessary, press ESC until MENU appears
above F2.
2.FromtheSETUPMENU,usethe▲▼
buttons to select O
2
REFERENCE. Press
ENTER to display the O
2
Reference Screen.
3.Usethe▲▼buttonstoentertheO
2
reference
value.
4. Press ENTER to save the selection and re-
turn to the SETUP MENU or ESC to revert
to the previous setting.
3.5.6 Print Pressure
Select whether to print or not print the pressure measurement on the com-
bustion test printout as follows:
1. Enter the Setup Menu per Section 3.5.1. If necessary, press ESC
until MENU appears above F2.
2.FromtheSETUPMENU,usethe▲▼but-
tons to select PRINT PRESSURE. Press
ENTER to display the O
2
Reference Screen.
3.Usethe▲▼buttonstoselectYESorNOto
print the pressure measurement.
4. Press ENTER to save the selection and re-
turn to the SETUP MENU or ESC to revert
to the previous setting.
3.5.7 Zoom
Combustion test data in the Run/Hold screen can be shown with enlarged
characters to make viewing easier. The operator can set zoom levels to
Standard,2Xor3X.TheStandardzoomsettingwilldisplay4linesof
combustiontestdataatonetime;2Xwilldisplay3linesofdatawithen-
largedcharacters;3Xwilldisplay2linesofdatawithenlargedcharacters.
The operator can scroll through the complete list of measured and calcu-