Quick start guide

Instruction 0024-9393
12
Fyrite Pro Quick Start Guide
Saving Test Data in Memory Up to 10 individual sets of test data can be saved in memory as follows:
Note: When memory is full, the next reading saved will over- write the oldest reading. Note: The analyzer’s setup information is stored along with the test data. For example, temperatures stored in °C are recalled and printed in °C even if the analyzer is currently set up for °F.
1. With the analyzer is in its Run Mode, press the HOLD button twice
to display the Print Screen.
2. Press the  button once to display the Save Screen. The number
shown in this screen represents the memory location (1 thru 10) to which the current test data will be saved.
3. Press ENTER to save the test data and return to the Hold Mode, or
press HOLD to return to the Hold Mode without saving.
Opening and Viewing Saved Test Data Perform the following to open and view saved test data:
Note: If no test data has been saved, the option to open the memory for viewing will not be available.
1. With the analyzer is in its Run Mode, press the HOLD button twice
to display the Print Screen.
Instruction 0024-9393
9
Fyrite Pro Quick Start Guide
Figure 4. Model 125E Run Mode Screens
Fuel Select: F1 = Natural Gas F2 = Propane F3 = Light Oil F4 = City Gas Stack Temperature & Draft Draft Zero Stack Temperature & Efficiency Ratio of CO to CO
2
qA & Excess Air (LAMBDA) TL & Eta CO & CO Air Free (Undilute) CO
2
&
O
2
E N T E R
.