Operating instructions

b. Disassembly. Remove the cover (2J)
from the reservoir (2B) by using a com-
bined twisting and pulling motion. Unscrew
the center rod assembly (2G) from the body
and plunger assembly (1) and remove the
O-ring (2H). Slide the filter element (2D),
filter washer (2E), and filter spring (2F)
off the center rod assembly (2G). Remove
the upper and lower filter gaskets (2C)
from the filter element. Remove the res-
ervoir (2B) from the body and plunger as-
sembly (1) and the seal (2A) from the
reservoir.
c. Cleaning. Clean the parts thoroughly
with an appropriate solvent (par. 23).
d. Inspection and Repair.
(1) inspect the cover (2J), O-ring (2H),
reservoir (2B), center rod assem-
bly (2G), filter spring (2F), filter
washer (2E), upper and lower
gaskets (2C), and seal (2A) for
being in good condition (par. 22b).
(2) Replace with new, the filter ele-
ment (2D) and all other parts de-
termined not in good condition.
e. Assembly. Install the seal (2A) on
the bottom of the reservoir (2B) and mount
the reservoir on top of the body and
plunger assembly (1). Slide the filter
spring (2F), filter washer (2 E), and O-ring
(2H) onto the center rod assembly (2G).
Place the upper and lower gaskets (2C) on
the filter element (2D) and slide the filter
element onto the center rod assembly (2G).
Screw the center rod assembly into the
body and plunger assembly (1). Install the
cover (2J) on the reservoir (2B).
Note.
One end of the filter element is red and
marked “top”. Be sure the element is installed
with this end in the upward position.
1 - Body and plunger assembly
A–Body and plunger
B–Handle
2 - Fuel reservoir assembly
A - Seal
B - Reservoir
C - Upper and lower gasket
D - Filter element
E - Filter washer
F - Filter spring
G - Center rod assembly
H - O-ring
J - Cover
3 - Discharge block assembly
and hydraulic pressure gage
4 - Socket head cap screw
Figure 3. Fuel reservoir assembly,
15