Operating instructions

APPENDIX IV
REPAIR PARTS AND SPECIAL TOOL LISTS
Section I PREFACE
1. General
a. This appendix is a list of repair parts
which may be required by the using organ-
ization for performing organizational
maintenance but are not authorized to be
stocked. These items are to be requisi-
tioned as required for immediate use only.
b. For prices of items of Ordnance ma-
teriel, see the appropriate supply manual
of the SM 9-2 series. Prices of items that
are the responsibility of other commodity
commands may be obtained from the ap-
propriate type 2 supply manuals for those
commands.
c. Additional applications of items in
this manual are listed in the supply man-
uals of the SM 9-3 series.
2. Requisition Notes
a. Repair Part Identified by Federal
Stock Number.
(1)
(2)
(3)
If the exact item requisitioned is
not furnished, or if other action is
necessary, the exact nature of the
action taken by the commodity
command will be indicated by
standard symbols on prescribed
forms.
When requisitioning an item, the
requesting agency will order the
listed item. However, the com-
modity command will take neces-
sary action to issue the exhaust
stock item until stock is exhausted,
whether it be an individual item,
kit, set, or assembly.
Requisition for replacement of
items that are the responsibility
of commodity commands will be
submitted to the commodity com-
mand indicated in column 1a, Ma-
teriel Code Number.
b. Part to which FSN has not been as-
28
signed. When requisitioning a C source
(local procurement) item identified only by
a manufacturer’s part number, it is man-
datory that the following information be
furnished the supply officer:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Manufacturer’s code number (5
digit number preceding the colon
in the descriptive column).
Manufacturer’s part number (the
number,
and sometimes letters,
following the colon, (1) above).
Dashes, commas, or other marks
must be included exactly as listed.
Noun name and dimensions, if nec-
essary.
Name of manufacturer of end item
(from cover of TM or manufac-
turer’s name plate).
Federal stock number of end item
(from TM).
Manufacturer’s model n umber
(from TM or name/data plate, pre-
ferably name/data plate).
Manufacturer’s serial number
(from name/data plate).
Any other information such as type,
frame number, and electrical
characteristics, if applicable.
If DD Form 1348 is used, fill in all
blocks except 4, 5, 6, and Remarks
field in accordance with AR 725-50.
Complete form as follows:
(a)
(b)
In blocks 4, 5, and 6, list man-
ufacturer’s code, and manufac-
turer's part number (as listed in
description column).
In Remarks field, list noun name
(repair part), end item applica-
tion (FSN of end item), manufac-
turer, model number (end item),
serial number (end item), and
any other pertinent information
such as frame number, type, etc.