Specifications

MODEL 300 COMBUSTION ANALYZER
SPECIFICATIONS
GENERAL
Size .................................... Carrying Case: 18" x 14" x 8"
(45.7 x 35.6 x 20.3 cm)
Standard Probe: 11.5" (29.2 cm)*
Hose - 22' (6.7 m)*
Weight ................................ 15 lbs. (6.8 kg)
Materials ............................ HDPE Case, medium gray; polycarbonate
membrane switch; stainless steel probe
Calibration Interval ........... 60 seconds
Storage Environment ......... – 4 to 122°F (–20 to 50°C),
0 to 100% relative humidity
Operating Environment .... 32 to 104°F (0 to 40°C),
0 to 99% relative humidity, non-condensing.
Sample Gas Flow ............... 0.7 to 1.5 liters/min
Power source ...................... Either 120 VAC, 240 VAC, or internal battery
pack per sales order
BATTERY PACK SPECIFICATIONS
(A battery-powered unit may be run off the charger, if required.)
Output Voltage: .................. 5 VDC
Charging Input Voltage: .... 8 VDC from Bacharach Charger
(Refer to Section 6 for part numbers)
Charging Time: .................. 5-6 hours
Operating Time ................. At least 200 sequential combustion tests, or 4
to 6 hours (min.). The analyzer will operate an
addtional 1 hour (min.) after the BATTERY
STATUS light goes out. These discharge times
are based on worst-case-continuous-operating
conditions, which include printing every
20 minutes. A typical discharge time of a fully
charged battery pack is between 12 and
16 hours.
iv Instruction 24-9223