Specifications

Instruction 19-9326
7
Monoxor III
3.3 Front Panel Pushbuttons
Note that a push button may perform several functions, depending on what
screen is being displayed at the time.
I/O • Turns analyzer ON/OFF. There is a 10 or 60 second warm-
up and a 5 second turn-off-delay period.
• Places the analyzer into either its Setup or Calibration Mode
when used in conjunction with the ENTER or HOLD button.
• Bypasses the CO purge function during turn-off.
 • Causes the displayed value to increase or change while in
the Calibration or Setup Mode.
 • Causes the displayed value to decrease or change while in
the Calibration or Setup Mode.
ENTER • Starts a test – pump ON.
• Sets up the analyzer to be placed into its Calibration Mode
when held down with the analyzer OFF. (Used in conjunc-
tion with the I/O button.)
• Stores the displayed value and automatically steps to the
next screen when pressed during calibration or setup.
• Displays the CO screen when held down for 2 seconds while
in the Calibration Mode.
• Aborts turn-off and keeps the analyzer turned ON when
pressed during either the 5 second turn-off-delay period, or
the CO purge cycle.
HOLD • Freezes the display and stops the pump during a test.
• Starts a printout when pressed twice with the pump run-
ning, or when pressed once with the pump OFF.
• Sets up the analyzer to be placed into its Setup Mode when
held down with the analyzer OFF. (Used in conjunction with
the I/O button.)
LIGHT Toggles the backlight ON and OFF.