Specifications

Instruction 19-9326
3
Monoxor III
2.0 TECHNICAL CHARACTERISTICS
CO Display Range ...................... 0–2000 ppm
Accuracy ..................................... ±5% of reading or ±10 ppm,
whichever is greater*
Resolution ................................... 1 ppm
Response Time ........................... 90% of nal value within 40 sec.
Battery Requirement ................. Four disposable ‘AA’ Alkaline batteries
Operating Time .......................... Up to 18 hours continuous (pump running
and backlight off)
Warm Up Time ........................... 10 or 60 seconds (depending on CO
channel zero setup, refer to Page 9)
Display ........................................ 4 digit by 2 line, 7-segment Liquid Crystal
Display
Front Panel Controls .................. Six push button switches
(refer to Section 3.3)
Operating Temperature:
Analyzer ................................. 32–104 °F (0–40 °C)
Probe ....................................... 1000 °F (538 °C) max. at 5" insertion
Humidity ..................................... 15 to 90% RH (non-condensing)
Printer Port ................................ IrDA or HP protocol
Weight ......................................... 16 oz with batteries
Size .............................................. 7.5"H x 3.1"W x 2.1"D (190x79x53 mm)
* Tighter accuracy in the lower ranges, up to ±2 ppm, may be attained if a
lower range calibration gas (e.g. 100 ppm CO) is used.