Instruction manual

Instruction 19-9326
10
Monoxor III
3.4.4 Time Setup
There are two Time Setup Screens, one for hours and the other for min-
utes. Two bars appear above the segments being changed. The clock is in
a 24 hour format, but will appear as AM/PM on the printout.
�
1. Enter the Setup Mode per Section 3.4.1. If necessary, repeatedly
press ENTER until the rst Time Setup Screen is displayed—the
one with two bars over the hour digits.
2. Press the  or  button until the correct hour value is displayed.
3. Press ENTER to move the selection bars over the minute digits.
4. Press the  or  button until the correct minute value is displayed.
5. Press ENTER to move to the next Setup Screen, or I/O to exit setup.
3.4.5 Date Setup
There are two Date Setup Screens, each labeled “DAtE”. The rst screen
sets the month while the second screen sets the day.






1. Enter the Setup Mode per Section 3.4.1. If necessary, repeatedly
press ENTER until the rst Date Setup Screen is displayed.
2. Press the  or  button until the correct month is displayed.
3. Press ENTER to switch to the second Date Setup Screen.
4. Press the  or  key until the correct day is displayed.
5. Press ENTER to move to the next Setup Screen, or I/O to exit setup.