Specifications

Instruction 0019-9326
17
Monoxor III
4.10 Printing Test Results
Turn ON the printer. Refer to the printer’s
instruction manual for detailed operation and
maintenance information.
If not already done, set the printer param-
eters as follows:
• Data – 8 bits
• Baud – 9600
• Parity – None
• Handshaking – X-on/X-off
Align the printer with the top of the analyzer
as shown in Figure 4-1.
Begin printing by doing one of the following:
- If the pump is running, press the HOLD
button twice.
- If the display has been previously frozen,
press the HOLD button only once.
Tip: If the printer does not operate correctly,
ensure that the correct printer protocol has
been selected per Section 3.4.7.
Figure 4-1. Printer Alignment & Sample Printout
BACHARACH, INC.
MONOXOR III
=======================
DATE: 8/22/2003
TIME: 2:45 PM
CO 200 ppm
COMMENTS:
60°
max.
45 cm
(18 in.)
max.
ENTER
HOLD
I/O
LIGHT

