Specifications

PCA
3.0 SETTING UP THE PCA
3.1 Scope
Before using the PCA, you MUST:
Setup
• Check the batteries or plug in an Optional Power Supply (Section 3.2)
• Connect the probe to the analyzer (Section 3.3)
• Check the analyzer’s configuration (Section 3.4)
3.2 PCA Power
3.2.1 Checking and Replacing the Batteries
A fresh set of batteries is supplied with the PCA. Install the batteries as
described below. If a LOW BATTERY message is displayed when the
analyzer is turned on, replace the batteries.
1. Remove the battery cover from the back of the PCA (Figure 3-1).
2. Remove (and properly dispose of) any old batteries.
3. Insert a fresh set of four AA alkaline batteries, making sure to install
them per the “+” and “–” markings shown in the battery compart-
ment.
4. Replace the battery cover.
Figure 3-1. Battery Replacement
Instruction 0024-9219 3-1