Specifications

PCA
®
3
53
The stored logged data can either be viewed on the display using the
analyzer’s memory function (refer to Section 4.14), or downloaded to a
personal computer using the supplied Fyrite
®
User Software and USB
cable. Downloaded data is stored on the computer’s hard drive as a com-
ma-separated-value ASCII text fi le with a CSV extension, which can be
opened by most spreadsheet programs for analysis.
4.13.1 Turning ON Data Logging
IMPORTANT: Before turning ON data logging and starting
the data logging process, the analyzer should already be set
up to perform a combustion test per Section 4.5.
Turn ON data logging as follows:
1. Display the MAIN MENU by
pressing the MENU (F2) button. If
necessary, press ESC until MENU
appears above F2.
2. Use the ▲▼ buttons to highlight
SETUP, and then press ENT to
display the SETUP MENU.
3. Use the ▲▼ buttons to highlight
LOGGING, and then press ENT to
display the LOGGING screen.
TIP: The amount of memory available
for storing new data is displayed in
the LOGGING screen (maximum of
500 locations). If previous logging
sessions are stored, and additional
memory is needed, clear the logging
memory per Section 4.14.3.
NOTE: At no time will new logging
data over write old data.
4. Use the ▲▼ buttons to highlight
YES (turn logging ON).
5. Press ENT to make the selection and
display the LOGGING INTERVAL
screen.