Specifications

PCA

4.13.3 Starting the Data Logging Process

After turning ON data logging and setting

the interval and duration, the analyzer will

pause at the LOGGING SUMMARY screen,

where the currently selected interval and

duration time periods are displayed.

Press ENT to start the combustion test and

logging process. At this time the Combustion

Test LOG screen will appear, indicating that

the analyzer is now performing a combustion

test and the data is being stored in memory.

Note the following:

• At the top of the screen, the memory

location where the current log entry

is being saved is displayed.

• If there were previously stored log

entries, each new logging session

will start to store data in the next

available memory location.

• At no time will new data overwrite

old data.

4.13.4 Ending the Data Logging Process

Data logging will stop and the pump will turn OFF after the prescribed

duration, or after all 500 memory locations are ﬁ lled.

To exit the Combustion Test LOG screen, press the RUN/HOLD button

twice to display the Combustion Test HOLD screen.

Note the following:

• To end the logging process at any time, press the ESC button.

• If the logging process was stopped by pressing ESC, it cannot be

resumed without ﬁ rst turning logging back ON per Section 4.13.1.