Specifications

PCA
®
3
66
4.18 Printing Test Data
Combustion or pressure data that is currently being displayed can be sent
to a printer using IrDA protocol as described below.
Data that is stored in memory can also be printed by fi rst displaying the
stored test data as described in Sections 4.14.1 & 4.14.2.
In addition to printing combustion and pressure data, the contents of any
screen that shows the label “PRINT” above the F1 button can be printed.
For example, the information shown in the DIAGNOSTIC screen can be
printed.
1. Turn ON printer. Refer to the printer’s instruction manual for
detailed operating information. If not already done, set up the
printer for:
• 8 bit
• No parity
• 9600 baud
• IrDA is set to IrDA-SIR
• DTR handshaking
2. Align the printer with the top of the analyzer as shown in Figure
4-4.
3. Press the PRINT (F1) button to begin printing.
The printout shown in Figure 4-4 shows typical combustion-test results of
an analyzer containing O
2
, CO
Low
, NO, and NO
2
sensors. Note that since
the SO
2
sensor is not installed, three stars (* * *) appear in their data
fi elds.