Specifications

Pur•Chek

™

Instruction 2100-900014

TO CHANGE

SETTINGS OR

REPLACE PAPER

ROLL PRESS SET

FOR OTHER HELP

PRESS HELP

Figure 25.

Figure 26.

SET HELP DONE SET FEED DONE

TO FEED IN A

NEW PAPER TOLL

PRESS FEED

PRESS SET TO

ADJ LCD CONTRAST

OR ELEVATION

Figure 27.

TO LOAD PAPER

1. PRESS FEED

2. INSERT PAPER

3. PRESS STOP

4. PRESS TEST TO

TEST AND EXIT

FEED STOP TEST

Open the printer door and remove the old roll by tearing the paper as it enters the printer then pressing the

“FEED” button shown in Figure 27 until the old roll exits the printer completely. Insert the new paper roll from

the underside as shown below:

CORRECT

INCORRECT

Press the “FEED” button shown in Figure 27 to automatically advance the paper through the printer. When

the paper appears on the top of the printer, press the “STOP button. Press the “TEST” button to print a test

message and verify that the paper is installed properly. Slide the paper through the slot in the printer door and

close the door.

5.6 Low Battery Warning

For units equipped with the optional rechargeable battery, a “Low Battery Warning” will appear when the battery

is nearly exhausted. Several tests may be run after the initial warning however, it is strongly recommended that

the unit be recharged or the external battery clips be used. Allowing the battery to fully discharge may greatly

affect its service life.

5.7 Error Messages

In the unlikely event that an “Error” message is displayed on the screen, power off the unit, take it to a location

outside of the shop environment where fresh air is available and turn the unit back on. If the “Error” message

reappears, refer to the help screens on the instrument or contact our service department for assistance.