User`s manual

9
DEVICE EXPLANATION
9 - 16
9.2 Internal User Devices
9.2.6 Link relay (B)
(3) Using link relays in the network system
In order to use link relays in the network system, a network parameter setting is
required.
The link relay range where network parameter setting has not been made (not used
by the MELSECNET/H network system, etc.) is available as the internal relays.
POINT
The MELSECNET/H module includes 16384 link relay points, while the CPU
module includes 2048 points (default).
When using the link relays after the above points, change the number of link relay
points in the device setting of the PLC parameter dialog box.
Remark
Refer to the following manual for the network parameters.
Q Corresponding MELSECNET/H Network System Reference Manual
(PLC to PLC network)