User`s manual

App - 22
Appendix 4 Restrictions on Using MELSECNET/H Module in the Safety
CPU Module
APPENDICES
Appendix 4 Restrictions on Using MELSECNET/H Module in the
Safety CPU Module
(1) Network parameter which can be set in the safety CPU module
When using MELSECNET/H module in the safety CPU module, network parameter of
MELSECNET/H which can be set in GX Developer is shown in TableApp.19.
: Available,
: Not available
Remark
For network parameter of MELSECNET/H, refer to the following manual.
Q Corresponding MELSECNET/H Network System Reference Manual (PLC
to PLC network)
TableApp.19 List for network parameter which can be set in GX Developer
Parameter setting item Use permitted/prohibited
Network type
MNET/H mode (control station), MNET/H EX (control station)
MNET/H mode (normal station), MNET/H EX (normal station)
MNET/10 mode (control station)
MNET/10 mode (normal station)
MNET/H standby station
Starting I/O No.
Network No.
Total number of (slave) stations
Group No.
Mode
Network range assignment (common parameters)
Station inherent parameters
Refresh parameters
Interrupt setting
Control station return setting
Standby station compatible module
Redundant setting
Inter-link data transfer
Routing parameters
Valid unit in access to another station