User`s manual

Installation Mounting the base unit
9 – 14
Screw the DIN rail in two places using the mounting screws and square washers included with
the adapters in ‘Position A’ (bottom of base unit).
Screw the DIN rail with mounting screws (obtained by user) in ‘Position B’ (where the base unit
is not installed).
The following shows where to position the square washers and the mounting screws included
with adapters.
Fig. 9-12: DIN rail mounting for the base units Q38B, Q312B, Q68B, Q612B, Q38RB, Q68RB,
Q65WRB, Q38DB and Q312DB
Fig. 9-13: DIN rail mounting, when there is large vibration or impact
NOTES Use the DIN rail that is compatible with M5 size screws.
Use only one washer for each mounting screw. Use only the square washers supplied with
the adapters.
If two or more washers are used together for one mounting screw, the screw may interfere
with the base unit.
Make sure to align the square washer sides with the DIN rail.
DIN rail
35 mm
200 mm or less
200 mm or less
200 mm or less
BA B
Stopper
Mounting screws
(included with adapters)
Square washers necessary
Mounting screws
(obtained by user)
No square washers
Stopper
200 mm or less
Square washer
DIN rail
Side view A
Square washer
Side view ATop view
Mounting screws (M5x10)
Mounting
screws DIN rail
Mounting side
(e. g. Control panel)
Square washer
DIN rail DIN rail
Square washer