User`s manual

Mounting the base unit Installation
MELSEC System Q, Hardware 9 – 15
Adapter installation method
The way to install the adapters for mounting a DIN rail to the base unit is given in following figure.
QH00004C
Fig. 9-14: Adapter installation method
Base unit rear
Führen Sie den Winkel des kleinen
Adapterstückes in die untere
Öffnung ein.
Push the top of the
adapter (small) far
enough until it "clicks".
Insert the adapter (large) into the grooves of the
base unit from below.
Push the bottom of the adapter (large) far
enough until it "clicks".
Place the hook of the adapter
(small) in the lower hole.