User`s manual

Installation Mounting the base unit
9 – 16
Stopper mounting
When using the DIN rail in frequent vibration and/or shock prone environment, use stoppers
included with the DIN rail mounting adapter.
Fig. 9-15: Stopper mounting procedure
Hook
Hook
Stopper

Loosen the screw at the top of the stopper.
(2 stoppers are needed)

Hitch the lower hook of the stopper to the bottom of
the DIN rail. Install the stopper with the arrowhead
side facing up.

Hitch the upper hook of the stopper to the top of the
DIN rail.


Slide the stopper to the end of the base unit so that
they are fully in contact.
Stopper

DIN rail



Tighten the screw of the stopper with a screwdriver.
(Tightening torque 1.00 to 1.35 Nm).
(Left side)

Make sure that the left and right stoppers are fixed
securely to the DIN rail.
Stopper
DIN rail


(Right side)
Stopper Stopper