Owner`s manual

ENGLISH
15
Once you have located another signal in SP mode, begin to move
in that direction. If the distance consistently decreases, you are
going in the right direction. Travel far enough in SP mode to confirm
the distance is decreasing and which way the flux line is trending.
If more than one signal is being displayed and it becomes unclear
which one to pursue, continue in the direction you have been
searching. Always switch back to SE mode when you think you are
getting closer to beacon 2 than beacon 1.
If after finding a victim, no further signals are detected in SP mode,
continue the search if there are still missing victims. Revert to search
mode and perform a signal search of the remaining unchecked areas
within the debris pile. Resume your signal search at the point where
it was originally abandoned.
For more details on multiple burials, please refer to our website:
www.backcountryaccess.com.
Operating Instructions
2
In special mode (SP), all signals
are shown, but Tracker acts as a
“spotlight” with narrowed vision:
approximately 75 degrees in front
and in back of the searching beacon.
Only the signals within this angle
(beacon 2) are shown. This 75° angle
corresponds to the Tracker’s center
three lights.
Always switch back to search mode
(SE) when you’re more than halfway
from beacon 1 to beacon 2.
Figure I
Special (SP) mode