Assembly Instructions

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
HEX.KEY WRENCH 4MM
BOLT M6*15
BOLT M6*25
TILE C 324*473*148.5*10
TILE A 299*448*148.5*10
TILE B 299*448*148.5*10
FIGURE 1
LEG
SUPPORT
TABLE TOP
TCS67SE
PARTS LIST
PART
NO.
MATERIAL CODE PART Q’TY
PART
NO.
MATERIAL CODE PART Q’TY
1
2
3
4
1
2
2
2
4
1
5
8
7
9
10
11
12
13
14
4
16
2
TCS67SE-CS05-1
TCS65SE-CS04-1
TCS67SE-CS04-2
13C??7G1300A001
17KAA0101----Y4
CENTER CONNECTOR WITH RING
TILE D 324*473*148.5*10
TILE E 600*600*10
TILE F 600*148.5*10
2
2
2
13C??7G1300A002
13C??1B0200A001
13C??2CF100A001
13C??7G1200A001
13C??7G1200A002
1
3
3
2
2
2
2
2
COURTYARD CREATIONS INC.
PAGE 1 OF 2
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
17C40A0709001YX
62TCS67SEY101
Attention:
Make sure that each bolt needed for all steps matches the
corresponding figure to ensure proper assembly.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
!
6
17C40A0705001YX
E-2
15
#11 BOLT M6*15
HEX.KEY WRENCH 10MM
1
17KAC3101----Y3
Note:
The tiles are easy to be broken, be careful when you remove
them.
12
11
11
Step 1:
Place the table top (#1) onto a non-abrasive surface, such as
a carpet, with its underside facing upwards. Fasten the legs
(#2) and the supports (#3) to the underside of the table top
(#1) rim by using bolts (#11 and #12). Keep the bolts loose.
See Figure 1.
25
#12 BOLT M6*25