Assembly Instructions

PART
NO.
PARTS LIST
Attention:
Make sure that each bolt needed for all steps matches the
corresponding figure to ensure proper assembly.
Note:
Make sure that bolts on the seat assembly (#1) are loose
prior to assembling this chair. See Figure 1.
MATERIAL CODE PART Q’TY
1
2
3
4
5
2
6
4
1
1
1
1
9
8
10
11
12
13
14
1
KTS606P-CS03-1
KTS606P-CS02-1
KTS606P-CS04-3
KTS606P-CS01-2
KTS606P-CS01-3
17KAA0101----Y4
17XA3309
SEAT ASSEMBLY
BACK ASSEMBLY
RIGHT ARM
LEFT LEG
LEFT ARM
BOLT M6*15
BOLT M6*35
HEX. KEY WRENCH 4MM
STEEL WASHER
PAGE 1 OF 2
17C40A0712001YX
17C40A0705001YX
FIGURE 2
Use the correct bolts as indicated. Do not tighten any of the bolts until the chair is completely assembled.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
COURTYARD CREATIONS INC.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
2
2
17C02A0712001YX
17C40A0709001YX
17KAC3101----Y3
1
HEX. KEY WRENCH 10MM
E-2
Step 2:
Insert legs (#5 and #6) to the support brace (#7), fasten
them by using bolts (#9) and steel washers (#12). Keep the
bolts loose. See Figure 2.
Note:
The labels marked “L” and “R” on the legs (#4 and #5) should
coincide with Figure 2 to ensure proper assembly.
7
5
6
L
R
BOLT M6*35
FIGURE 1
2
8
1
KTS606P-CS08-5
SUPPORT BRACE
1
7
6 1
KTS606P-CS04-4
RIGHT LEG
1
PART
NO.
MATERIAL CODE PART Q’TY
BOLT M6*25
Step 1:
Insert legs (#2) to the support brace (#1), fasten
them by using bolts (#8). Keep the
bolts loose. See Figure 1.
#8 BOLT M6*25
#9 BOLT M6*35
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE INTENDED FOR RESIDENTIAL USE ONLY.
35
9
12
SKU#2725353 / MODEL#18S0116T (KTS606P)